BUY WITH CONFIDENCE. 100% SATISFACTION GUARANTEED OR YOUR MONEY BACK.

Menu 0
Home Products PURINIZE® 2400-GALLON DIY WATER TREATMENT + FILTER PACK
PURINIZE® 2400-GALLON DIY WATER TREATMENT + FILTER PACK

PURINIZE® 2400-GALLON DIY WATER TREATMENT + FILTER PACK

$599.95

  • Make your own two-bucket gravity water purification & filtration system in case of emergencies with the PURINIZE® 2400-GALLON DIY WATER TREATMENT + FILTER KIT.

    This powerful kit reduces/inactivates biological and chemical contaminants including bacteria, viruses, protozoa, pesticides, herbicides, fungicides, heavy metals, pharmaceutical drugs, VOC's, disinfectants, disinfection byproducts, and more. Treats up to 2400 gallons of water from any freshwater source - no pumping, back-logging, electricity, or harsh chemicals required. Great for families or groups. 

    KIT INCLUDES:

    12 - PURINIZE® Water Purifier, 1 L
    (Treats up to 200 gallons of water)
    1 - 0.2-Micron Ceramic Filter
    1 - Spigot

    Does not include drill, drill bits, or buckets.

        

    • WHAT YOU NEED:

      1 - PURINIZE® DIY WATER BUCKET KIT
      1 - 1/2" Drill Bit
      1 - 3/4" Drill Bit
      1 - Drill
      2 - 5-Gallon Buckets with Lids
    • DIRECTIONS:
    1. (Bucket 1)Drill a hole in the bottom center of 1 bucket using the 1/2" drill bit. Also, drill a hole in the center of one of the lids using the 1/2" drill bit.
    2. Place Ceramic Filter on the inside of the drilled bucket and attach it from the bottom using the rubber gasket and wingnut. Tighten until slightly snug. (DO NOT OVERTIGHTEN!)
    3. (Bucket 2) Drill a hole in the side of the second bucket several inches above the bottom of the bucket using the 3/4" drill bit. Insert water spigot and attach from inside using the rubber gasket and nut provided. Tighten until slightly snug. (DO NOT OVERTIGHTEN!)
    4. Place lid with a hole drilled into it on top of Bucket 2.
    5. Fill Bucket 1 with water and treat with the proper amount of PURINIZE®. Place Bucket 1 on top of Bucket 2 so that the Ceramic Filter spout fits in the hole of the lid on top of Bucket 2

  • As the Ceramic Filter gets clogged, rinse clean after each use. If the Ceramic Filter is rinsed clean but still shows signs of a slow drip rate then you will have to do a slight surface scrub. Gently scrub the outside of the filter using the green side of a sponge. Never use soap or detergents because they may clog the filter. The Ceramic Filter should be replaced every 1,000 gallons. 

    Flow Rate: You should see a drop rate of 30-60 minutes per gallon of water. Because the filter system relies on gravity, the more full the top bucket is the faster the drip rate will be. You may drill additional holes and install up to 3 total filters for much faster flow rates. This is not required and will only increase the flow rate of the system.